After some discussion of How to Use a Big Ruined Factory Feature For Crossfire I’ve gone ahead and painted it. Actually it comprises the two ruined factory features from Wargames Tournaments and a lot of rubble that I added.
The ruined factory
I put each of the two features on a 180mm x 180mm base board. Although the shell of the building is from Wargames Tournaments I added some walls and a lot of rubble within. Some of the walls extend into the upper floors. Most of the rubble is on the ground floor although I put a bit on upper floors.
I used the rubble to delineate the internal rooms. This should be obvious from the photo of configuration a (I explain the various configurations below).
In the earlier post I asked for advice on how to organise the rooms within the factory. I’ve gone for two room sizes, 120mm x 60mm and 90mm x 60mm. The room schematic is as follows:
These two features give me a few possible layouts for the two features in combination.
I’ve been quite active recently. At least I’ve assembled and/or painted quite a lot of buildings. Many ruined.